Piercing An Ear

This is the steralizing step. Start boiling your water and getting a clean and open area to pierce your clients ear at. Once your water boils, drop the ring and needle into the water. Let boil for a few minuets then turn fire off and take your equipment out. Make sure you have all your equipment close to you so you dont have to run across room to grab anything during process. Make sure to wash your hands with soap.

Now take some rubbing alcohol and dab it on a paper towel. Wipe the spot you are going to pierce. Once done grab your marker and mark the spot were the ring is going to go. Let your friend up to check to see if he/she wants it were you marked it.

Grab your needle and gently put on the marker dot. Once you know that you have the needle exactly on the marked spot shove through. The needle should have a hole in it at the tip for the ring.

Take the ring, insert it into the hole of the needle. Now slowly take it the needle out of the pierced spot. The ring will follow. Now take the needle out and screw on the balls,spikes,dice or put the backing onto the ring. Wipe up the blood if any and your done.